TN100 Tubing Notcher

LARGE CAPACITY AND LOW OPERATING COST - The TN-100 Tubing Notcher will notch 3/4" through 2" O.D. tubing at angles up to 50 degrees in under 15 seconds. It uses commonly available bi-metal hole saws costing approximately $8 each. A single bi-metal hole saw will typically notch 5 to 10 complete racecars.

EASY TO USE - The TN-100 Tubing Notcher may be mounted in a drill press or simply clamped in a vise and used with a 1/2" hand drill. The 1/2" hand drill setup is by far the best in our opinion. In this way the TN-100 can be laid horizontal and when notching 45 degree angles the floor will not interfere with the tubing being notched. Also, since the hand drill is fed in horizontally, the drill’s weight doesn’t try to force the hole saw in too fast.

HEAVY DUTY FRAME - Entirely CNC machined, the frame is made from 1/2" thick 6061-T6 and its entire face has been milled flat. The degree increments are then machined directly into the frame. This eliminates the problem of metal chips eating away at a decal. An all position swivel insures an easy setup.

GROUND AND POLISHED STAINLESS STEEL SHAFT & RIGID BEARING BLOCK - This is the most critical part of a hole saw style tubing notcher. The TN-100 utilizes a ground & polished stainless steel shaft riding in a bearing block incorporating twin needle bearings and separate grease seals for maximum rigidity and reliability. We could have used a cheaper mild steel shaft and inexpensive bronze bushings, but then you’d be replacing them every job and cussing us too.

STRONG, ACCURATE TUBE CRADLE - As can be seen in the picture, the tubing notchers entire cradle assembly has been designed to be tough, accurate and easy to use. By CNC machining the cradle out of a solid steel block we know the tube will be notched in the exact middle. Plasma cut and welded cradles can’t come close to the accuracy of the TN-100. The clamp mechanism rides in its own guide and has also been machined from a solid block of steel. This eliminates the problems of tube walk in tube notchers that use a U-strap.

Only $197.50

does not include hole saw

Click Here For Hole Saws